If your stereo system is too loud for your neighbors, muffle the sound in the room where the speakers are with lots of padded and textile-covered surfaces, upholstered furniture and rugs, for example.
#ONKYO CD PLAYER MECHANICAL ERROR MANUAL#
On the Onkyo website, the owners manual can be downloaded and shows clearly. The cd player can be connected via RCA cables, Coaxial cable or the preferred Digital cable to a reciever or amplifier. If the issue is still unresolved after performing these troubleshooting steps. Being that I own and have installed this player I can tell you 100 percent that this can only be used as part of a receiver configuration. Play a CD to confirm the issue is resolved. Hold these buttons down until the ALL CLEAR or ALL ERASE message is displayed. If you want and have the ability to access secondary audio on your BD player you have to. * If the blowout recurs, have the receiver professionally repaired. Press the ALL CLEAR or CLEAR button, then press and hold down the POWER button on the CD player at the same time. Your Amp is playing HD audio it s just that the Blu-ray Player is doing the decoding (and outputting the HD audio as PCM via HDMI to your AVR) rather than the Player sending Bitstream (via HDMI) to the AVR and the AVR doing the decoding. * Reset the breaker or replace the fuse with one of the same rating. If all of your stereo components stop working, find the receiver’s circuit breaker or fuse, usually on the back panel, and: Replace any fuses with exact duplicates from an electronic shop. * Your receiver may have speaker fuses or circuit breakers on its back panel next to the speaker connections. If your stereo suddenly stops working, but the receiver’s panel lights do not dim or go off:
#ONKYO CD PLAYER MECHANICAL ERROR TV#
Spray TV tuner cleaner (available at electronic shops) into all hard-to-reach contact points.
Use fine sandpaper to remove corrosion from metal surfaces. * If wire-jiggling eliminates the problem, clean all terminals, lugs, connectors and jack plugs at both ends of the wire. Such repairs are best done by a professional. If both speakers now work, the problem is in the turntable, CD player or tape deck. * If the speaker remains dead, the receiver is probably at fault. * If the problem persists, turn the receiver’s program selector from “Phono,” “CD” or “Tape” to “FM Tuner.” * If no change occurs, switch the plugs that fit into the jacks on the back of the receiver. * Jiggle the dead speaker’s wire where it connects to the receiver. Mostly The cd is jammed between the laser sensor and the cd rotator.Try removing the audio player and reseting the whole device if possible.Or if you have sufficient technical know how.Open the player try to manually open the disc tray.and remove thedisc.This can happen even if the disc is broken inside the. If only one speaker works when you operate the phonograph:
0 kommentar(er)
